Digital laser power probes

From Macken

Our digital laser power probe is a completely portable, easy-to-use calorimeter type power meter. The instrument consists of two components: a microprocessor-based digital meter and a probe head.

Different probe heads are available to cover various laser types with power ranges from a few watts to over 11 kW. The meter accepts any of the probe heads so it is easy to change power ranges as well as check a reading using a second probe head of the same type.

Features
Measures laser power from 20 W to over 11 kW
Increased accuracy due to the microprocessor control and a digital readout
Readings are retained until the meter is reset
Inexpensive and easily switched Power Probes
Computer chip in the Power Probe Head contains calibration information

Like our highly successful dial type Analog Laser Power Probes, the Digital Power Probe uses timed exposures and is based on the idea that the laser power measurement should be quick and easy. Setup should not require special fixture or time consuming alignment. Ideally, it should be possible to take power measurements at any point in the optical system where losses are likely to occur.

Unfortunately, most laser power meters have sacrificed ease of use to gain continuous power readings. In most laboratory and production situations; however, the usual requirement is for quick power spot checks with minimum disruptions.

Probe head selection

Eight different Probe Heads are available for use with the DM5 Digital Meter. The Probe Heads have four different power ranges (designated D1, D2, D3, D4). The Probe Heads are also available with two absorbing coatings designated Y and C.

The Y series probe heads have a broad spectral absorption coating that is particularly useful for YAG lasers but covers a spectral range from 0.4 to 6 microns. This coating can also be used with CO2 lasers.

Specification probe head
Probe HeadModell D1-C & D1-YModell D2-C & D2-Y*Modell D3-C & D3-Y*Modell D4-C & D4-Y*
Useful power range [W]20 to 220100 to 1100200 to 22001000 to 11000
Exposure time [s]20202010
Resolution [W]0,11110
Head diameter [mm]38 (C)/38 (Y)48 (C)/63 (Y)60 (C)/76 (Y)76 (C)/88 (Y)
Head length [mm]12 (C)/10 (Y)50 (C)/25 (Y)58 (C)/33 (Y)88 (C)/55 (Y)
Accuracy [g]±5±5±5±5
Repeatability [%]±1,5±1,5±1,5±1,5
NIST Certificaton requeston requeston requeston request
*Note: The D2C, D3C and D4C probe heads are conical

If the Probe Head is to be used with only a CO2 laser, then the C coating is preferred. The C coating does not exhibit damaged until the aluminum substrate is close to melting. The D3C and D4C Probe Heads are conical in shape allowing for a higher damage threshold.

Contacts

Request further information
Product Manager
+39 06 5004204
Fax: +39 06 5010389

Our partner

Follow us: twitter linkedin facebook
European offices
© LOT Quantum Design 2016